Odor neutralizer for body armor, cases and helmets MAMO 250 ml, spray (plate carriers, pads, helmet liners, backpacks; cordura, mesh, eco-leather, helmet foam; water-based, unscented)

MAMO odor neutralizer for body armor — a spray for equipment that is worn on the body for hours and cannot be washed daily: body armor covers, plate carriers, helmet pads and helmet liners. Eliminates sweat odor caused by bacteria, rather than masking it with fragrance. Leaves no traces.

Where the odor comes from
Sweat itself has almost no smell — the odor is produced by bacteria that multiply in the damp mesh, lining and foam of the pads. Airing dries the fabric, but does not remove the cause: as soon as the equipment gets wet again, the odor returns. That is why the product is applied to the inner side of the cover and pads — where sweat accumulates.

Disinfection action. In the initial treatment mode, it destroys bacteria, fungi and enveloped viruses (influenza, coronaviruses).

What to treat
– body armor covers and plate carriers — inner side, mesh, lining;
– helmet pads and helmet liners;
– backpacks, covers, textile equipment — straps, back panel, belt.
Materials: cordura, mesh, eco-leather, textile, helmet foam, polyurethane coatings, membranes. Do not treat ballistic packages — covers and pads should be removed first.

Application method
Initial treatment

1. Remove covers and pads from ballistic elements. Soiled ones — wash without conditioner and rinse twice.
2. Generously spray the inner side (mesh, lining, pads) from 15–20 cm until fully saturated — 100–150 ml/m², in two passes with a 5 min interval. Helmet pads can be soaked in the product for 15–30 min and wrung out.
3. Keep wet for 30 min (in a bag), then completely dry before wearing.
4. Repeat for 2–3 days in a row.

Maintenance
After each wear, spray the inner side until lightly moistened and dry.

Consumption
“Cover + pads” set — approximately 80 ml per one treatment. 250 ml bottle — starter course for one set.

Warning
Not for skin treatment, do not apply to body. Spray in a well-ventilated area, do not inhale aerosol, do not spray near face. Avoid contact with eyes; if contact occurs, rinse with water. If swallowed, rinse mouth, drink water, consult a doctor. Do not mix with other products; conditioners and laundry detergent residue reduce effectiveness. May cause allergic reaction. Harmful to aquatic organisms with long-term effects — avoid release into the environment. Keep away from children. Store at +5…+25 °C in a tightly closed container, do not freeze.

Composition
Water, polyhexamethylene guanidine hydrochloride 0.5%, didecyldimethylammonium chloride 0.15%, non-ionic surfactants < 5%, glycerin, propylene glycol, zinc pyrrolidone carboxylate (Zinc PCA).

Characteristics

Frequently asked questions
How to remove odor from a body armor if the cover hasn’t been washed for a long time? — Remove the plates and ballistic packets, wash the cover without conditioner and rinse twice. Then perform initial treatment: spray the inner side generously, keep it wet for 30 minutes, dry it — and repeat for 2–3 days in a row.
Does it work as an odor neutralizer for a helmet? — Yes: helmet pads can be sprayed or soaked in the product for 15–30 minutes and wrung out. Dry completely before wearing.
How to treat the helmet liner? — With the same product: spray until wet and let dry completely. Do not apply to skin or body.
Is it suitable as an odor spray for body armor with eco-leather or membrane? — Yes: the water-based formula is safe for eco-leather, polyurethane coatings, cordura and membranes and leaves no marks.
How long does a bottle last? — For a starter course for one set of “case + pads”. For further maintenance, you will need one more.

From the same line: blood stain remover 100 and 500 ml; military uniform laundry concentrate 50 ml; fleece antistatic 100 ml.